$40.00
The technology in the Patented IRAD make it the ultimate installation tool. It provides solutions to 3 very specific problems faced in today’s installations. This easy to program device allows you to add a switched 12-volt output, a remote output with adjustable delay and a relay/solenoid control to overcome the issues created by vehicles with start/stop systems.
IRAD Features
Automatic 12V Ignition Detection and +12V Output Generation
Generated +12V Remote Output (direct or linked to IGN)
Stop-Start Relay/Solenoid Control Mode
Independent Adjustable IGN & REM Turn-On/Off Delays
>750mA Continuous Current Per Output
Compact Aluminum Chassis w/Detachable Mounting Tabs
Locking Detachable Terminals
Chassis Dimensions: 0.79”x1.5”x1.5” (20x38x37mm)
Quick viewWhen upgrading your audio system in a typical front, rear and subwoofer set-up, the link6 is the perfect tool for the job. Getting its input from your factory stereo’s front and rear speaker leads, it can provide front, rear and subwoofer outputs for your aftermarket amplifier or amplifiers.
Some factory audio systems require summing when adding aftermarket amplifiers, because no full range signal is present. When this is necessary, the link6 combines the sum of the frequencies present, providing the full range signal your amplifiers need.
For added flexibility, the link6's multi-function remote provides four unique configurations, based on the specific application requirements of your system. It can work as a subwoofer level control for fine tuning the amount of bass in your system, or as a master volume control in more complex installations.
Quick viewThere are certain types of music that just don’t have enough good, low bass. If you listen to classic rock, older hip-hop or Banda music, you know that something is missing. The bassRESTOR fills in the gaps and adds just the right amount of bass back into your music. A unique Multi-Function Remote Level Control (RLC) lets you adjust the overall bass volume, the amount of bass restoration effect needed for a particular song or defeat the effect completely when no restoration is required.
The bassRESTOR has both speaker level and RCA inputs, so it integrates easily with factory or aftermarket sources. There is a variable frequency subsonic filter for fine system tuning.
Quick viewIf you need a high-quality 2-channel LOC, but don’t require additional features like summing or auxiliary inputs, the link2 is the perfect solution. It is extremely small so it will fit almost anywhere, simplifying installations.
It has OEM load detect for factory systems that require resistance to function properly. The link2 will accept up to 40V RMS through its speaker inputs, while delivering up to 10V RMS of output at less than 50 ohms.
Quick viewThe linkDQ has the same class leading LOC and line driver that are the core DNA of all Wāvtech products. The linkDQ features an adjustable parametric EQ with narrow or wide range selection, allowing corrections to any low frequency deficiency that may be present in a factory audio system. It features auto turn-on via DC-offset or Audio Signal Detect, either of which can be easily defeated by the convenient jumpers on the end panel.
Has a RJ45 port for easily upgrading to a remote level control (sold separately). This allows for fine tuning the systems bass output from the front of the vehicle.
Reviews
There are no reviews yet.