DSP

DSP

Showing 1–6 of 8 results

  • Quick view

    WAVTECH bassRESTOR Bass Restoration Processor

    $195.00

    There are certain types of music that just don’t have enough good, low bass.  If you listen to classic rock, older hip-hop or Banda music, you know that something is missing.  The bassRESTOR fills in the gaps and adds just the right amount of bass back into your music.  A unique Multi-Function Remote Level Control (RLC) lets you adjust the overall bass volume, the amount of bass restoration effect needed for a particular song or defeat the effect completely when no restoration is required.

    The bassRESTOR has both speaker level and RCA inputs, so it integrates easily with factory or aftermarket sources.  There is a variable frequency subsonic filter for fine system tuning.

    Add to cart
  • Quick view

    WAVTECH IRAD Ignition/ Remote Generator + Delay

    $40.00
    The technology in the Patented IRAD make it the ultimate installation tool.  It provides solutions to 3 very specific problems faced in today’s installations. This easy to program device allows you to add a switched 12-volt output, a remote output with adjustable delay and a relay/solenoid control to overcome the issues created by vehicles with start/stop systems.
    Add to cart
  • Quick view

    WAVTECH link2 2-Channel LOC

    $65.00

    If you need a high-quality 2-channel LOC, but don’t require additional features like summing or auxiliary inputs, the link2 is the perfect solution.   It is extremely small so it will fit almost anywhere, simplifying installations.

    It has OEM load detect for factory systems that require resistance to function properly. The link2 will accept up to 40V RMS through its speaker inputs, while delivering up to 10V RMS of output at less than 50 ohms.

    Add to cart
  • Quick view

    WAVTECH link4 4-Channel LOC w/Summing and Remote

    $149.00

    When it comes to adding an amplifier or amplifiers to your factory audio system, the link4 does what models from competing brands just can’t.  Simply put, it is the most flexible 4-channel LOC available today.

    The link4 can directly accept 4-channels of input and give you 4-channels of output.  It can accept 2-channels of input and give you 4-channels of output.  If you input 4-channels, you can sum them down to 2-channels of output and pass through another 2-channels for retained sub level control.  It even has a 3.5mm Auxiliary Input so you can add your phone or other portable device to the system.  No other 4-channel LOC can do all of that.

    As an added bonus, it includes a "Patent Pending" Multi-Function Remote Level/Source Control that can adjust your subwoofer output level, the volume of the auxiliary source or serve as a Master Volume Control for your entire system.  This is especially useful in OEM systems where speed sensitive volume dependent equalization is present.

    Add to cart
  • Quick view

    WAVTECH link6 6-Channel LOC w/Summing and Remote

    $195.00

    When upgrading your audio system in a typical front, rear and subwoofer set-up, the link6 is the perfect tool for the job. Getting its input from your factory stereo’s front and rear speaker leads, it can provide front, rear and subwoofer outputs for your aftermarket amplifier or amplifiers.

    Some factory audio systems require summing when adding aftermarket amplifiers, because no full range signal is present. When this is necessary, the link6 combines the sum of the frequencies present, providing the full range signal your amplifiers need.

    For added flexibility, the link6's multi-function remote provides four unique configurations, based on the specific application requirements of your system. It can work as a subwoofer level control for fine tuning the amount of bass in your system, or as a master volume control in more complex installations.

    Add to cart
  • Quick view

    WAVTECH link8 8-Channel LOC w/Summing and Remote

    $230.00

    Today’s factory installed audio systems are becoming more complex.  With many of the vehicle controls and operations integrated into the source unit, replacing it is no longer an option.  Some vehicles have amplifiers dedicated to each individual speaker. When you aren’t satisfied with the OEM system sound, these factors make it increasingly difficult when it comes time to upgrade.  That is why you need a link8.

    The link8 is about as versatile as an analog integration product can be.  The link8 has 8-channels of high level inputs that can be configured in a number of ways.  With just 2-channles of input, signal can be achieved at all 8-channels of output.  With 4-channels of input, you can have front, rear and subwoofer output.Even when summing a 4-way system to full-range, subwoofer level control can still be retained. These are just a few of the configurations available via the link8’s convenient external controls.

    Another benefit of the link8 is the auxiliary input.  This provides access to your phone or other mobile device through the audio system.  The "Patent Pending" Multifunction Remote level/Source Control can switch between your subwoofer output level, the volume of the auxiliary source or even serve as a Master Volume Control for your entire system.  This is especially useful in OEM systems where volume dependent equalization is present.  You can even program the remote so the priority of knob functions are tailored to your specific system needs.

    Add to cart

Skip to content