$29.95
The linkRC is the add-on remote level control (RLC) for the linkDQ. It is also a replacement for some legacy models (see below).
Compatible Models
linkDQ
linkQ
bassFREQ
linkRC Features
Remote Level Control
Compatible Models
linkDQ
linkQ
bassFREQ
Includes 5M (16.4ft) Flat RJ45 Cable
Removable 2-piece Housing Design
Custom Flush Mountable
Break Away Mounting Tabs
Dimensions (w/o knob & tabs): 1.1”x1.5”x1.8” (28x38x45mm)
Quick viewIf you need a high-quality 2-channel LOC, but don’t require additional features like summing or auxiliary inputs, the link2 is the perfect solution. It is extremely small so it will fit almost anywhere, simplifying installations.
It has OEM load detect for factory systems that require resistance to function properly. The link2 will accept up to 40V RMS through its speaker inputs, while delivering up to 10V RMS of output at less than 50 ohms.
Quick view
Quick viewWhen it comes to adding an amplifier or amplifiers to your factory audio system, the link4 does what models from competing brands just can’t. Simply put, it is the most flexible 4-channel LOC available today.
The link4 can directly accept 4-channels of input and give you 4-channels of output. It can accept 2-channels of input and give you 4-channels of output. If you input 4-channels, you can sum them down to 2-channels of output and pass through another 2-channels for retained sub level control. It even has a 3.5mm Auxiliary Input so you can add your phone or other portable device to the system. No other 4-channel LOC can do all of that.
As an added bonus, it includes a "Patent Pending" Multi-Function Remote Level/Source Control that can adjust your subwoofer output level, the volume of the auxiliary source or serve as a Master Volume Control for your entire system. This is especially useful in OEM systems where speed sensitive volume dependent equalization is present.
Quick viewWhen upgrading your audio system in a typical front, rear and subwoofer set-up, the link6 is the perfect tool for the job. Getting its input from your factory stereo’s front and rear speaker leads, it can provide front, rear and subwoofer outputs for your aftermarket amplifier or amplifiers.
Some factory audio systems require summing when adding aftermarket amplifiers, because no full range signal is present. When this is necessary, the link6 combines the sum of the frequencies present, providing the full range signal your amplifiers need.
For added flexibility, the link6's multi-function remote provides four unique configurations, based on the specific application requirements of your system. It can work as a subwoofer level control for fine tuning the amount of bass in your system, or as a master volume control in more complex installations.
Reviews
There are no reviews yet.